Fitting Guide

Fitting your wash-time bath barrier is easy if you follow these simple steps, no assembly is required. Ensure you fit your barrier before your dog enters the bath. Suitable for non-textured baths up to 570mm wide.

STEP 1

Wet the suction cups thoroughly.

Wetting the suction cups

STEP 2

Flex the barrier as shown with your thumbs to the front of the faceplate. Position the barrier in the bath to section off the required area.

bend the barrier to fit the bath

STEP 3

Push down firmly with one hand on each of the curved handles.

Push both hands down

STEP 4

In addition, push down firmly on each suction cups to ensure the cups are stuck to the bottom of the bath.

Push down the suction cups

STEP 5

Ensure the barrier is watertight by running your finger along the flexible seal to make sure it is flat.

STEP 6

You can now fill bath to the required depth or just keep it in position when you use the shower.

Wash-time barrier

STEP 7

To remove the barrier, release the suction cups one by one by pulling each pull-tab upwards to break the seal.

Pull up the suction cups to release

For more information visit our FAQs.